Search the Community
Showing results for tags 'blade force'.
Found 1 result
Hi All, A little new to the world of cutters and vinyls still. I bought my Roland cutter second hand from a family member. Eventually, it came time to change the blade. Some of my dinosaur clip-art was showing need of dental work. Small things didn't cut well, and the dots on 'i's began to peel up. I watched some tutorials, then braved up to changing my blade with one of the Roland Cemented Carbide blades that came with the machine. It is a 45 degree I am fairly sure. I moved the blade force down to the recommended 60gf for the Premium vinyl from Stahls and moved the pen force down to zero. Performed a few test cuts and the new blade performed beautifully. Ah, the wonders of a fresh blade, I thought, excited to fill new orders. A couple of days later I came back to cut vinyl. Everything was peeling up. The cuts were dash cut. Letters were coming up. I adjusted the gf and pen force and did more test cuts until it appeared it all had improved. Next vinyl run, just as awful. Then I realized my cutting strip had a few gouges in it from a couple of times my vinyl had come off the tracks. I turned it around after placing an order for another one. Check my blade's edge, exposure, rotation, etc. etc. upped the pen force to +2 and after a few more test cuts, found ABSOLUTELY NO improvement. I am pulling my hair out now. I am getting uncut corners in the insides of Ns, Ms, Ws, etc. Letters are still peeling up to the point I wonder if my vinyl is just a bad batch with no stick.... For help, my cutter's specs are: 20cm/s 70gr 0.25mm Thank you for your help,