Search the Community
Showing results for tags 'Print & Cut'.
Found 3 results
-
XC-540 print cut will not stay calibrated
xtremesigns posted a topic in Roland Printer Support Requests
My XC-540 printer will not stay calibrated. I can get it set then on the next job it will be off by 1/2 inch or so. What might be the problem? when I calibrate I always 0 it out, then set calibration is this the correct way?- 1 reply
-
- contour cut
- cut line
-
(and 2 more)
Tagged with:
-
Ok, so having a little bit of an issue. I am printing on a printable vinyl with my Epson 1431 with pigment ink then using a cold laminate over them so can be used outdoors then using a USCutter LaserPoint II cutter with SCAL Pro 3. The issue i am having is that the cutter isn't cutting along the lines and so every cut is different. When i go in and do the print cut, after i print the vinyl and place in the cutter, i do a laser alignment then proceed with the alignment of the registration marks. Once all 3 have been aligned, click cut and as you can see from the pics, it is not cutting on the marked lines and not the same on each row. I have tried several different times and same results. I have made sure the alignment of the registration marks are dead on, made sure to calibrate the laser before alignment and cutting, made sure the blade holder is seated and fastened correctly. I have ran a test cut with paper and pen adapter attached and made adjustments and rerun then when i would get it to where i am ok with it, i would run the vinyl and would be off. In the attached picture, i actually did 5 test runs with paper and pen and yet this is still the outcome. I just can't figure out if it is on the software or cutter end. So any suggestions would be greatly appreciated and thanks in advance......
- 4 replies
-
- Print Cut
- Print and Cut
-
(and 3 more)
Tagged with:
-
Won't print .png image with registration marks for contour cut
akorcovelos posted a topic in Sure Cuts A Lot Pro
Hi, I am pretty new to vinyl cutting but I've gotten pretty good at basic sign lettering and one color window decals, as well as layered multi-color decals. I'm now trying y hand at contour cutting printed vinyl decals and I've hit a wall...In SCAL3pro I'm trying to print the image (.png brought in from Inkscape) but it either prints only the registration marks, or it errors out on the plotter saying 'no pages were generated'. Plotter is an Oce Colorwave 650. My main question is, how do you print a .png image with registration marks from SCAL? I've searched high and low and only see reference to Signblazer or other software that didn't come with my Laserpoint II cutter. Since this is thesoftware that was provided with the cutter, and the LPII is supposedly a contour cutting machine, what am I doing wrong? I've been going to the File>Print menu, selecting the plotter and checking the Print with registration marks' and 'Print outlines only'. I've also tried checking only the 'Print with registration marks' and still no luck...This seems like it should be a simple thing, but it has me stumped. Does anyone have experience with this, or know of any tutorials that actually relate to SCAL? I tried to attach the file in question but it says it's too big. Thanks!- 2 replies
-
- png
- registration
-
(and 2 more)
Tagged with: