Search the Community

Showing results for tags 'Print Cut'.

More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • Welcome to USCutter
    • Shop Online
    • Customer Support
    • Information For New Equipment Owners
    • Website and Company Feedback
  • Equipment Discussion & Support
    • Vinyl Cutters
    • Heat Presses
    • Competitor Cutter Help
    • Printers
    • Laminators
    • Engravers
  • USCutter Community
    • Community Rules & Announcements
    • Introductions
    • General discussion
    • Show your work
    • Instructional Contributions
    • T-Shirts and/ or Garments
    • Sublimation
    • Business Practices, Sales and Pricing, etc.
    • Mac Users Board
    • Pre-sale questions
    • Off Topic Section
  • Software Discussion & Support
    • VinylMaster CUT, LTR, PRO & DSR
    • Sure Cuts A Lot Pro
    • Signcut
    • SignBlazer
    • Flexi
    • Corel Draw
    • Adobe Illustrator
    • Inkscape
    • Other Software Programs
  • Material Discussion
    • Vinyl
    • Other Materials
  • Feedback Section
    • Criticism and Complaints about USCutter
    • USCutter Equipment Feedback or Suggestions
  • Graphic help and requests
    • General Help
    • Vectorizing
    • Graphic Requests
    • Fonts

Find results in...

Find results that contain...

Date Created

  • Start


Last Updated

  • Start


Filter by number of...


  • Start





Website URL







Found 1 result

  1. Ok, so having a little bit of an issue. I am printing on a printable vinyl with my Epson 1431 with pigment ink then using a cold laminate over them so can be used outdoors then using a USCutter LaserPoint II cutter with SCAL Pro 3. The issue i am having is that the cutter isn't cutting along the lines and so every cut is different. When i go in and do the print cut, after i print the vinyl and place in the cutter, i do a laser alignment then proceed with the alignment of the registration marks. Once all 3 have been aligned, click cut and as you can see from the pics, it is not cutting on the marked lines and not the same on each row. I have tried several different times and same results. I have made sure the alignment of the registration marks are dead on, made sure to calibrate the laser before alignment and cutting, made sure the blade holder is seated and fastened correctly. I have ran a test cut with paper and pen adapter attached and made adjustments and rerun then when i would get it to where i am ok with it, i would run the vinyl and would be off. In the attached picture, i actually did 5 test runs with paper and pen and yet this is still the outcome. I just can't figure out if it is on the software or cutter end. So any suggestions would be greatly appreciated and thanks in advance......