Search the Community
Showing results for tags 'Not closing'.
Found 2 results
Hello every body, i recently bought a US Cutter Plotter MH871-MK2, when i sent a file to cut (pen or knife) the lines won't close, i try different things like updating drivers, speed, different softwares, blade and presure is fine.. I run out of ideas i need some help..
MH721 28" Bought about 6 months ago Windows 8,7, and XP machines Latest drivers Sure Cuts a Lot Pro 3.053 USB (high quality cable) but I know, USB sucks. First month, machine was okay. It would close most cuts but sometimes would go on a fritz and start cutting all over my vinyl wasting 2-3 feet of vinyl. I stopped using the machine because of this but now recently I need to use it again. Settings are 50mm/s and 90 pressure. On standard Oracal Calandered white vinyl. Even when I use the machines "test" it will not close the cuts, at all. Leaving a good 1mm gap after each cut. Machine is grounded and I tried wiping down with one of those dryer cloths. Any ideas? I have been loosing my mind googling this.