Search the Community
Showing results for tags 'Graphtec CE6000'.
Found 2 results
Hello everyone I'm using a graptec CE6000 and I'm cutting quite heavy film, when the blade cuts up the grain it's trapping the film, how can I train the blade to cut down and not up, when it goes down I have no problem. I'm using AI CS and cutting master 3. Any help would be very much appreciated Thanks Steve
I am cutting out oval stickers, 48 per sheet for a total of 2,000 stickers. Most sheets cut with no issue, but every so often a sheet will start the cutting out of position and eventually correct it self while cutting. So in the end perhaps 12 stickers are ruined. Any ideas why and how to prevent this? Thanks Morrie