Search the Community

Showing results for tags 'sound'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Welcome to USCutter
    • Shop Online
    • Customer Support
    • Information For New Equipment Owners
    • Website and Company Feedback
  • Equipment Discussion & Support
    • Vinyl Cutters
    • Heat Presses
    • Competitor Cutter Help
    • Printers
    • Laminators
    • Engravers
  • USCutter Community
    • Community Rules & Announcements
    • Introductions
    • General discussion
    • Show your work
    • Instructional Contributions
    • T-Shirts and/ or Garments
    • Sublimation
    • Business Practices, Sales and Pricing, etc.
    • Mac Users Board
    • Pre-sale questions
    • Off Topic Section
  • Software Discussion & Support
    • VinylMaster CUT, LTR, PRO & DSR
    • Sure Cuts A Lot Pro
    • Signcut
    • SignBlazer
    • Flexi
    • Corel Draw
    • Adobe Illustrator
    • Inkscape
    • Other Software Programs
  • Material Discussion
    • Vinyl
    • Other Materials
  • Feedback Section
    • Criticism and Complaints about USCutter
    • USCutter Equipment Feedback or Suggestions
  • Graphic help and requests
    • General Help
    • Vectorizing
    • Graphic Requests
    • Fonts

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 1 result

  1. Hello All! I'm using 2x FC2250 plotters. One for 8 years and 1 for 6 years already. Both in tilted position, table is about 55-60 degr. to horizontal. I'm concerning about behavior of the pen block while in "pause" - top-right position. The thing is that in this position Y-motor seems to get a signal that penblock moves down for a micron, so it makes step up, then block moves again down and so on with frequency of 30-50 Hz. As a result, the Y-motor in PAUSE produces a buzzing noise or, sometimes, rhythmic sound like "UP-down-down-Up-down-down" with frequency of 2-3 Hz. I'm concerning of this, because the Y-motor is expensive (you wouldn't believe that in Finland it is 800 euro and in Russia it is 500 euro!!! Stupid and not the best servo-motor!) On my old plotter I've already replaced one (thanks to Ukraine - bought there for just $200, as this amount now is huge there). The motor damage was the wear-out bearing, so I made a conclusion that unnecessary movement is bad for this motor... So my questions for FC2250/2240 owners and technical guys: 1. Does your plotter produces the same thing with the same sound? 2. May be the reason of this wrong (excessive/weak) Y-motor's belt tension? Actually while installing the new motor, I had no gauge so I set the tension just "feel to be the same" as it was... 3. Is it any deep settings of 2250 to make HOME position not top-right but bottom-right? This will also save a Y-motor yield with no inconvenience at all... Many thanks to all! PS: If needed I could share the source of really cheap (couple of bucks) and fairly reliable CB15U blades. I'm cutting hard film, mylar 125 mic, and one blade works for two-three moths! Also I found a good supplier of CB15U blade's holder, for $15 and it works fine, cut preciously and so far works for 6 months without visible signs to be dead...