Search the Community

Showing results for tags 'error message'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Welcome to USCutter
    • Shop Online
    • Customer Support
    • Information For New Equipment Owners
    • Website and Company Feedback
  • Equipment Discussion & Support
    • Vinyl Cutters
    • Heat Presses
    • Competitor Cutter Help
    • Printers
    • Laminators
    • Engravers
  • USCutter Community
    • Community Rules & Announcements
    • Introductions
    • General discussion
    • Show your work
    • Instructional Contributions
    • T-Shirts and/ or Garments
    • Sublimation
    • Business Practices, Sales and Pricing, etc.
    • Mac Users Board
    • Pre-sale questions
    • Off Topic Section
  • Software Discussion & Support
    • VinylMaster CUT, LTR, PRO & DSR
    • Sure Cuts A Lot Pro
    • Signcut
    • SignBlazer
    • Flexi
    • Corel Draw
    • Adobe Illustrator
    • Inkscape
    • Other Software Programs
  • Material Discussion
    • Vinyl
    • Other Materials
  • Feedback Section
    • Criticism and Complaints about USCutter
    • USCutter Equipment Feedback or Suggestions
  • Graphic help and requests
    • General Help
    • Vectorizing
    • Graphic Requests
    • Fonts

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 3 results

  1. Hi, I have an older vinyl cutter that I got from a friend and am trying to get to work. I can not get a test cut to work on the cutter which is the step i need to do before i even try to connect it to any software. The manual says if it happens I should do this The PEN MODE LED and POWER/ERROR LED blink simultaneously This flashes if the location of the pinch rollers is not correct (that is, if the pinch rollers are not positioned above the grit rollers). If DIP switch SW-9 on the CM-24 is set to ON (piece material) and material with a vertical length of 100 mm (3-15/16") or less has been loaded, or if SW-9 is set to ON and there is no material over the front and rear paper sensors. You can cancel the error by pressing the SETUP key. Refer to "3-5 Loading the Material" to load the material correctly 12:00 i have the SW-9 switch on and my piece of vinyl is 24'' long it is also positioned over the leftmost grit roller correctly according to the pictures in the manual. I watched a lot of youtube videos on this and it seems like I am doing everything right. I attached a video of me doing it in case it helps. 20200808_111053.mp4
  2. Help! Has anyone seen the DRV ERROR - RESTART POWER message?? I have a TITAN 2 that is only 3 months old. I have ticket in with USC and was advised to move the carriage from left to right with machine off to correct error...no go on that one. I have disconnected all power sources as well to break connection. HELP? Have a big order to get out. Any advice appreciated.
  3. Out of no where SB freeze on me when I try to send it to the cutter screen and I get this at the bottom. Has anyone ran into this problem and have a fix for it?