jmh1789

Members
  • Content Count

    13
  • Joined

  • Last visited

Community Reputation

0 Neutral

About jmh1789

  • Rank
    Member

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. jmh1789

    What is going on????

    I guess I want to do six to try and cut down on waste. But if that's what it comes down to, I guess the headache isn't worth it.
  2. jmh1789

    What is going on????

    they aren't exactly 4 inch 3.624 to be exact.
  3. jmh1789

    What is going on????

    Page Bleed in VM, was set to .500. My understanding is that would mean it would cut .500 of an inch outside of the border? Or does that have nothing to do with my issue.
  4. jmh1789

    What is going on????

    Last two still over lapping. Maybe Ill just cut 5 at a time...
  5. jmh1789

    What is going on????

    Yes I did. I'm trying to cut now with the preserve cutting order option selected.
  6. jmh1789

    What is going on????

    Just tried again. Cut the first 4 perfect, the last two are over lapping each other when there should be 1/2 inch between them.
  7. jmh1789

    What is going on????

    Where is that option? I dnt seem to see it.
  8. jmh1789

    What is going on????

    It jumps all around. Cuts alittle bit here and there of each design. I'm using Vinyl Master Cut 4.0 I'm not to sure what you mean by matrix? Could you explain?
  9. jmh1789

    What is going on????

    Just tested with just a single logo, and it printed fine. I have to print over 100 of these things and I don't really wanna print one by one...
  10. jmh1789

    What is going on????

    I have 6 logos printing at a time, each measuring around 4x4. Also I have pulled some off the roll, also have let the machine pull it off with no change. I should also state that if I print one at a time it works fine. ALmost like it has something to do with the fact that I'm trying to print six in one print session.
  11. Attached is a picture of the problem I am having. Also attached is a picture of the design I am trying cut. When I set everything up to cut, it will cut about 90% of the design correctly, then all of a sudden it throws a part of the design all out of wack. Sometimes it will even overlap two separate logo that should be about 1/2 inch apart. I don't know if there is a setting I am missing or what. But I have a big order coming up and all of a sudden this things deciding to go funky on me. Please help! Also I should add I have been doing this for a very short period of time and I am self taught so all input is helpful! The picture is the best one I could get also. Thank You!