I have a couple Graphtec cutting plotter ce6000-60 machines
I have multiple issues with them, but my biggest issue is getting the settings correct.
I sent a couple test cuts to it, and the triangle is coming out terrible. I try weeding it, and from the start to finish point it is not connected, it stops cutting just a hair from the start point. I have tried to change offset, but it hasnt seemed to work. Also, the bottom of the triangle is curved up. i have reset the cutter which normally fixes these issues, but this time it didnt seem to help.
I have also replaced the cut strip and blade to no avail.
my current settings are
CBO9U Blade
Offset: 0
Speed: 30
Acceleration: 0
Cut Force; 20
1 pass
Tangential Mode Off