• Content Count

  • Joined

  • Last visited

Community Reputation

0 Neutral

About ASmith137

  • Rank
  1. I have a couple Graphtec cutting plotter ce6000-60 machines I have multiple issues with them, but my biggest issue is getting the settings correct. I sent a couple test cuts to it, and the triangle is coming out terrible. I try weeding it, and from the start to finish point it is not connected, it stops cutting just a hair from the start point. I have tried to change offset, but it hasnt seemed to work. Also, the bottom of the triangle is curved up. i have reset the cutter which normally fixes these issues, but this time it didnt seem to help. I have also replaced the cut strip and blade to no avail. my current settings are CBO9U Blade Offset: 0 Speed: 30 Acceleration: 0 Cut Force; 20 1 pass Tangential Mode Off