thehomemadeholidayshop
-
Content Count
7 -
Joined
-
Last visited
Recent Profile Visitors
827 profile views
-
SCAL4 pro issue help
thehomemadeholidayshop replied to thehomemadeholidayshop's topic in Sure Cuts A Lot Pro
My software is for MAC i was thinking of finding a refurbished one to dedicate to the cutter -
SCAL4 pro issue help
thehomemadeholidayshop replied to thehomemadeholidayshop's topic in Sure Cuts A Lot Pro
Really, I have never had a separate computer just for my cutter I will def. look into it thank you again! -
New Titan cutter need HTV help please
thehomemadeholidayshop replied to thehomemadeholidayshop's topic in Vinyl
Yes I tested on the vinyl first and then again on paper that was what the tutorial had said i went tried to make sure i had the blade barely out -
Hello! I just changed from SCAL4 to SCAL4 pro and now when I am cutting if i go to a screen away from sCAL (say to go print a label on my browser etc.) it stops cutting on my titan2 cutter? Does anyone have this problem is there a work around for it? Thank you!!!
-
New Titan cutter need HTV help please
thehomemadeholidayshop replied to thehomemadeholidayshop's topic in Vinyl
Yes i did a paper test for the blade length so that it would only cut through one paper with no marks on the 2nd paper that is good correct? As i typed my response to you about the 3 rollers it clicked that it must be that!!! seems to have done the trick!!!! Thank you so much for the help in working it out!!!! -
New Titan cutter need HTV help please
thehomemadeholidayshop replied to thehomemadeholidayshop's topic in Vinyl
I followed a tutorial for the blade depth and it seems to be okay it's easy to weed but not cutting the backing, i made sure the rollers are over 2 of the grit rollers. I am using 12" HTV as I have it left over from the silhouette so I have 2 rollers on the ends under the bottom rollers and then i have the 3rd positioned in the middle maybe this is the problem should i only use the 2 rollers for 12"? -
Hello! I have just switched over to a TITAN2 from a silhouette craft cutter. I am having some problems learning the machine. I believe I have figured out alignment and the pressure and speed seem to be okay but when I load the HTV it's bunching a little and not cutting accurately. Can anyone give any tips or suggestions on how to fix this? I am new to the boards and welcome any advice!!! Thank you very much! Michelle