sherndon1122
Members-
Content Count
7 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Everything posted by sherndon1122
-
Just setup my new laser point II plotter today, went to make my first cut after setup and noticed that when the cutter moves from one letter to the next it cuts off part of the previous letter? It seems to not be going up all the way when it moves to the next position or something? I have the blade depth set correct? Any suggestions would be appreciated!
-
Just setup my new laser point II plotter today, went to make my first cut after setup and noticed that when the cutter moves from one letter to the next it cuts off part of the previous letter? It seems to not be going up all the way when it moves to the next position or something? I have the blade depth set correct? Any suggestions would be appreciated!
-
cutting across letters?
sherndon1122 replied to sherndon1122's topic in Criticism and Complaints about USCutter
finally got it dialed in. less blade than what the recommendations called for and more pressure, around 187. SUCCESS!! -
cutting across letters?
sherndon1122 replied to sherndon1122's topic in Criticism and Complaints about USCutter
thanks for your time! -
cutting across letters?
sherndon1122 replied to sherndon1122's topic in Criticism and Complaints about USCutter
it' not cutting into the vinyl backing! cut1.svg -
cutting across letters?
sherndon1122 replied to sherndon1122's topic in Criticism and Complaints about USCutter
it's cutting a straight line down the middle of the artwork and cutting across letters as it moves from one to another?? -
cutting across letters?
sherndon1122 replied to sherndon1122's topic in Criticism and Complaints about USCutter
I thought that might be the issue, so I deactivated it and reactivated the software again, still same issue. blade depth is correct! I'm using sure cuts a lot software on a mac using usb.