Lucky90210

I'll definitely reach out to them for assistance, thanks bud

Anyone know of a software program that I can cut from with my "MASTER TIGER SERIES 1000" ? FlexiSign 10 didn't seem to support my plotter. Thanks in advance

Hell yeah, there's almost too much info, I'm overloading myself. Great though

Woah, I just started that explains me always being in the Help Sections

How long have you been doing This for Mz ?

Excuse my French lol, She... I thought Mz was an abbreviation for something else

Listen to Mz SKEETER, he knows what he's talking about

Okay, I have SignCut Productivity Pro, and your plotters driver are here so you should get it. They have a trial version, I suggest that just to see if it detects your machine.

What's software programs do you have to cut ?

Wildgoose, I installed SignCut, Found my manufacturer (Master), but my cutter isn't there. Any clue as to which other drivers might work for it ?

I'll definitely try that WildGoose, I'll let you know how it goes

Yes I have, I'm gonna wait till I purchase the Serial to Serial. I'm done with it for now, thanks for all the advice & I will let you guys know how it goes when I receive the new cable

Thanks bud, is there anything else I can try ?

.

This is what appeared on the plotter, and it just makes a loud noise while being stationary

From what I've read the past few hours, support doesn't really help. The solution to my problem is in this forum, I know it is. I put the port settings exactly the same in both "Device Manager & Flexi " but still doesn't do anything.

I managed it to stop saying "Write Port Error" in production manager, now it it just loads 0%-100% and the machine does nothing

Yes, I've been up all night trying to get this thing to work. Extremely Frustrated, been waiting for a reply and been reading a lot but still can't figure it out

Okay so now that I've set up the plotter with flexi sign, when I try to send a job, it idles at 0% for about 20-30sec then it says "Write Port Error". I've seen a couple of posts about this problem but I can't figure it out, the plotter does test cut. Any ideas ?

No I did not, I'll have a look. As for the Seiki Plotter I managed to get it running, this is a plotter my dad bought from a flea market and it's just been sitting around collecting dust so I thought I'd try to get it running. Thanks for the fast response

My brother figured it out, accidentally downloading the x64bit drivers instead of the x32bit. Thanks again bud

I recently just got Flexi Sign 10 and I'm trying to send a job from my Seiki Tech 1350T using the program but in production manager it says "Cannot open port". I've tried the other ports that it lists but none work. I'm using a USB 2.0 Cable. Any Help Thanks in advance

I'll definitely consider that if I can't find a solution. Thanks for the fast response btw.

I sure did, I've been at this for almost 2 hours and still can't get it to cut