Smalibu046

yes when you turn the laser light on, the display for it will change to "Off". This is so that next time you select it, it turns it off. Yeah i know it is backwards kinda, but guess it would make sense that when it is off and want to turn it on that you click "On" and same for turning it "Off".

Ok, so having a little bit of an issue. I am printing on a printable vinyl with my Epson 1431 with pigment ink then using a cold laminate over them so can be used outdoors then using a USCutter LaserPoint II cutter with SCAL Pro 3. The issue i am having is that the cutter isn't cutting along the lines and so every cut is different. When i go in and do the print cut, after i print the vinyl and place in the cutter, i do a laser alignment then proceed with the alignment of the registration marks. Once all 3 have been aligned, click cut and as you can see from the pics, it is not cutting on the marked lines and not the same on each row. I have tried several different times and same results. I have made sure the alignment of the registration marks are dead on, made sure to calibrate the laser before alignment and cutting, made sure the blade holder is seated and fastened correctly. I have ran a test cut with paper and pen adapter attached and made adjustments and rerun then when i would get it to where i am ok with it, i would run the vinyl and would be off. In the attached picture, i actually did 5 test runs with paper and pen and yet this is still the outcome. I just can't figure out if it is on the software or cutter end. So any suggestions would be greatly appreciated and thanks in advance......

Ok, so having a little bit of an issue. I am printing on a printable vinyl with my Epson 1431 with pigment ink then using a cold laminate over them so can be used outdoors then using a USCutter LaserPoint II cutter with SCAL Pro 3. The issue i am having is that the cutter isn't cutting along the lines and so every cut is different. When i go in and do the print cut, after i print the vinyl and place in the cutter, i do a laser alignment then proceed with the alignment of the registration marks. Once all 3 have been aligned, click cut and as you can see from the pics, it is not cutting on the marked lines and not the same on each one. I have tried several different times and same results. I have made sure the alignment of the registration marks are dead on, made sure to calibrate the laser before alignment and cutting, made sure the blade holder is seated and fastened correctly. I just can't figure out if it is on the software or cutter end. So any suggestions would be greatly appreciated and thanks in advance......