stealey1986

Members
  • Content Count

    9
  • Joined

  • Last visited

Community Reputation

0 Neutral

About stealey1986

  • Rank
    Newbie
  1. hi i have a graphtec fc3100-120. its been disconnected for a few months but was working in November. i have connected it back up to the computer it was running with sign blazer but when i send a job to cut it doesn't go to the cutter and the output on sign blazer says its idle?? any ideas please cheers
  2. stealey1986

    graphtex fc 3100-120 HELP!!

    hi i have a graphtec fc3100-120. its been disconnected for a few months but was working in November. i have connected it back up to the computer it was running with sign blazer but when i send a job to cut it doesn't go to the cutter and the output on sign blazer says its idle?? any ideas please cheers
  3. stealey1986

    Hi new to the group and could use some help

    your an absolute star, everything is working now i have that driver installd, thanks a lot
  4. stealey1986

    Hi new to the group and could use some help

    ok i have downloaded the 4200 series, now to be a real pain, how do i install it haha. im new to all this and just trying to get the cutter operational thanks for all your help
  5. stealey1986

    Hi new to the group and could use some help

    when i click the link it says 404 page not found
  6. stealey1986

    Hi new to the group and could use some help

    when i go into signblazer and try to do a cut on the graphtec it just starts cutting very small text or symbols down one side, so its connected but i have done something wrong?
  7. hi, i have an old graphtec fc3100-120 cutter. it used to be connected to a very old mac that died. now i want to connect it to a newer pc, i have got signblazer elements, got the connecter cable and linked them up, set the cutter to HP-GL mode, but now a bit stuck, someone reccomended that i need a driver for the pc, is there any free ones i can get to see if it works? and is there any other things i might need to do? thanks
  8. hi, i have an old graphtec fc3100-120 cutter. it used to be connected to a very old mac that died. now i want to connect it to a newer pc, i have got signblazer elements, got the connecter cable and linked them up, set the cutter to HP-GL mode, but now a bit stuck, someone reccomended that i need a driver for the pc, is there any free ones i can get to see if it works? and is there any other things i might need to do? thanks