Golem37

Members
  • Content Count

    5
  • Joined

  • Last visited

Community Reputation

1 Neutral

About Golem37

  • Rank
    Newbie
  • Birthday 11/04/1981

Profile Information

  • Gender
    Male
  • Location
    New Orleans
  1. Golem37

    Blade wont drop

    I was afraid of that. HAve alot to do and Im at work before they open and after they close. Oh well I'll figure something out Thank ou
  2. So i put in my graffic and hit cut. Everything started happening like normal but the blade wasnt dropping so I hit cancel. I reset the machine, hit test. The carriage traces the design out but the blade wont drop. I hit the enter key which makes the blade tap the vinyl - it hisses at me turn the machine off, back on, same issue thanks in advance
  3. Golem37

    Titan 2 ruler lines

    I talked to Support. He grabbed their demo version and it had the same issue too. He then told me to do the tape method The tape method is fine but I just expected the lines to match up after spending that much money
  4. Golem37

    Titan 2 ruler lines

    Thanks everyone! I just didnt want to void my warranty over something as dumb as peeled off sticker, but its happened to me before hence the hesitation.
  5. Brand new to the vinyl world so I apologize if I'm just over looking this. Trying to line up my vinyl and my front and back rulers dont match up like it does in the video. The front of the machine the numbers go low to high - from right to left. Now looking at it from the rear The rear of the machine does the same low to high right to left. Its like the measuring tape was suppose to be put on upside down but it wasnt and of course the numbers do not match up. any suggestions?