Hi All.
I am a total newbie in vinyl cutters & plotters.
To get an understanding of the software and hardware i have purchased a Creation PCut CT-630
My intention was to use it with a newer operating system with a USB cable, and have tried countless times and failed.
So i am using an older PC with a parallel port running on Windows 7 32bit
I understand that no drivers are needed with the parallel cable.. correct?
The plotter came with Artcut software 2005 which i initially setup to test. The plotter worked fine with no problems, but the software is very limited, so after looking at some forums i have installed signblazer.
I have been practising but when the plotter goes to cut, it goes through the motions but the blade does not come down to cut the shape / text.
Its driving me crazy so i was hoping someone might be able to help out.
i have read through the manual which doesnt really help me.
Any suggestions much apppreciated
thanks
Wayne