Stlouistech
Members-
Content Count
425 -
Joined
-
Last visited
Community Reputation
2 NeutralAbout Stlouistech
-
Rank
Advanced Member
- Birthday 01/01/1
Profile Information
-
Gender
Not Telling
-
How does everyone's black show up on the High Temp ink from Cobra ink? I did a shirt the other day and my black looks gray. Any thing I am doing wrong? Any Tips?
-
CE5000-60 Tighten blade carriage
Stlouistech replied to Stlouistech's topic in GraphTec Cutting Plotter Discussion
These are tight...The issue I have is that you can put your finger behind the carrage and move your finger towards you and it wobbles. It has play back and forth vertical wise....Hope that that is not confusing. Thanks...How would I tighten this? -
How do you tighten the blade carriage on the ce5000-60?
-
Graphtec CE5000-60 24"
Stlouistech replied to Stlouistech's topic in GraphTec Cutting Plotter Discussion
. -
Graphtec CE5000-60 24"
Stlouistech replied to Stlouistech's topic in GraphTec Cutting Plotter Discussion
The previous owner lives 8 hours away from me, the individual is a very known and well liked forum member. -
Graphtec CE5000-60 24"
Stlouistech replied to Stlouistech's topic in GraphTec Cutting Plotter Discussion
When I do the test cut from the Graphtec Cutting software, the circle is not even round, it turns out oval...he corner of the square also is not square...It is rounded like the "test" cut button. I will order some new blades tomorrow. Thanks for your help, hopefully the new blades fix it... -
Graphtec CE5000-60 24"
Stlouistech replied to Stlouistech's topic in GraphTec Cutting Plotter Discussion
Cutting strip is brand new, I will order a blade. I was reading on the T-shirt forum that people say the rails are out of alignment....Figures as I bought this used... -
Graphtec CE5000-60 24"
Stlouistech replied to Stlouistech's topic in GraphTec Cutting Plotter Discussion
Tried to get pictures, really can't...The test cut is pretty small....I also see when weeding the test cuts that the triangle inside the square does not have straight lines. This has me puzzled. -
Graphtec CE5000-60 24"
Stlouistech replied to Stlouistech's topic in GraphTec Cutting Plotter Discussion
I will try this, I think the blade is spinning freely....When I send a job to it, all the corners are at an angle... -
Graphtec CE5000-60 24"
Stlouistech replied to Stlouistech's topic in GraphTec Cutting Plotter Discussion
Nothing in blade holder, I am checking with the blade. The offset is at 0.... Drop of oil in the holder? -
Graphtec CE5000-60 24"
Stlouistech replied to Stlouistech's topic in GraphTec Cutting Plotter Discussion
Tried the offset, tried -1 through +5 and they all seem to have the same end result. -
Sent PM
-
I have a Grahtec CE5000-60.. When I do a test cut via the Graphtec, it cuts a square with a triangle in the middle of it. The issue I am having is that On the top right corner and the bottom left corner of the test cut square, those two are at an angle and not straight....Is this the offset?
-
Hello all, I am wanting to make some CornHole boards, does anyone have a template that I can use? I would need to get them printed from someone on the forum as well. Thanks in advance.
-
A couple cornhole boards I made for myself.
Stlouistech replied to Ursta Graphics's topic in Show your work
Excellent work!