KRStudios

Members
 View Profile  See their activity

  • Content Count

    3

  • Joined

  • Last visited

Posts posted by KRStudios

  1. Posted

    what is the blade offset set at?   It should be Zero  0....  Also have you tried the factory reset??  Turn power off,   turn cutter back on while holding down the UP arrow...  Also use overcut in your cutting software... 

     

    Is the carriage head snug and tight.. Carriage arm not broken?    White carriage wheels, down firmly in track? ,,  Make sure the grit rollers on the bottom are tight,   as well as the pinch rollers on top,,,

     

    Never be pulling directly from a roll of vinyl,  always have slack vinyl to pull from..  prefeed your vinyl..

    I found the other place to change offset and realized my plotter was set for a blade different than what i am using. THANKS! :)

    • Like 1

  3. Posted

    I have a Graphtec CE5000-120 and after someone (who shall remain nameless) used it, destroyed the cutting strip, and messed with settings, it is no longer closing the cuts on letters and shapes. 

     

    I have replaced the teflon cutting strip, I have changed out the blade and the blade holder, I have checked the blade and holder for dirt/vinyl reminants, etc; I have put a drop of oil into the holder, I have tried everything that I have seen suggested for people having a similar problem and nothing seems to be working. I am open to other suggestions! Thanks!!

     

     

    10620973_10202421670920810_1582372224_n_