GuerillaGrafix

You guys are a really great company and this forum has been very helpful. I Co sign most of the comments above. Maybe screenprinting frames, since I use my vinyl cutter to cut out stencils which can be placed on mesh screens to screen print apparel, walls, etc. Really great post.

Thank you all! Most of those suggestions helped the problem, but I am most likely going to wait until I get the 24in with the stand, since it will be easier to feed and I believe to be more sturdy. I would be cutting hundreds of these decals, so might as well do it the right way. Thanks for the tip about the blades. Nigel

Sup World, I am needing help cutting chrome vinyl. I have a 12" USCutter MH Series and purchased chrome vinyl to cut out small decals for an audio installer. I purchased the vinyl from http://www.hhsignsupply.com/productcart/pc/Chrome-Vinyl-c361.htm and I included a picture of my set up. The problem I am having is the vinyl sliding across the tracks and messing up the alignment of the cut images. I put the speed of the vinyl cutter at the lowest point and made sure it was aligned properly. I think it is because of the rigidness of the vinyl roll and it getting stuck and bunching up on the desktop the cutter is sitting on . Any help would be highly appreciated. Thanks, Nigel Guerilla Grafix

I haven't checked the paper invoice, but I was browsing through my emails from USCutter and in the invoice it was at the bottom with a link to SignCut Pro. I appreciate the help tho. Thanks, Guerilla Grafix

Hey, I just got my cutter and in the invoice it says I get a 1-year license with Signcut, but no software came with the cutter unless it's on this mini-CDR they shipped with the package. I can't check the contents of the CD, since my PC's CD drive is fried and it just gets swallowed by my MacBook's. I downloaded the trial version online and now my question is... Is there a way for me to receive the serial number from USCutter? Thanks for the help