Coffeelady

Members
  • Content Count

    4
  • Joined

  • Last visited

    Never

Everything posted by Coffeelady

  1. Coffeelady

    Craft Robo Info

    I am just starating out with a craft robo and this looks like it will be a great resource! Thank you! Coffeelady
  2. I am very new to vinyl cutting and just purchased a Graphtec Craft Robo CC330-L20 for personal use and gift making. All I have done so far is make the "test cut" following the instructions on the video. I placed my paper on the carrier sheet at the appropriate marks. I had my image placed within the cutting area in the robo software...note even close to the edge. When the image cut, it cut the edge out onto the carrier mat and off of the paper. Is there a setting somewhere that should be adjusted? I'm know it's probably pretty simple, but as I said, I am very new to this! Thanks for any input! Coffeelady
  3. Hello from north Georgia! I am very new to vinyl cutting and just purchased a Graphtec Craft Robo CC330-L20 for personal use and gift making. I didn't see a forum for this model...I know it's probably because this is just for "crafting", but I do have a question! ;o) Does anyone have a suggestion where a question about this machine may best be posted? In case anyone reading here may know the answer, here is my question. all I have done so far is make the "test cut" following the instructions on the video. I placed my paper on the carrier sheet at the appropriate marks. I had my image placed within the cutting area in the robo software. When the image cut, it cut the edge out onto the carrier mat and off of the paper. Is there a setting somewhere that should be adjusted? I'm know it's probably pretty simple, but as I said, I am very new to this! Thanks for any input! Sharon aka Coffeelady
  4. Coffeelady

    Hello from a newbie and a question

    Thank you all for the welcome! I will try posting my question in the Graphtec plotter forum, Paco. Have a great week! Coffeelady