Dr Smith

Anyone have the Starbucks "Guns and Coffee" vector they would like to share? Need to make a laptop sticker for my wife.

Anyone know where I could find/purchase these graphics? I'm not sure what you would even call them. I tried to trace them, but my tips of the graphics kept getting flat..thats a whole other post for Corel Draw section . I need them to be pretty much exaclty the same as the pic. Thanks

The pointy graphics do look a bit tribal..I'll check it out. Thanks

Anyone know of a good source for vector 600 sprint car templates?

Looks beautiful!

Thanks

I would probably be around .65 a piece. So about $325.. for a couple hours work at most.

One of the best ways to align the vinyl is to pull out a couple feet of vinyl before you put the rollers down. Take the part you pulled out the front and align it with the edges of the pre-feed vinyl underneath the cutter, then lower the rollers. This will usually get it spot on.

No need for any rulers on your cutter..Heck my $15,000 printer/cutter did not come with a ruler.

I use Cobra inks and the colors are excellent. And like mentioned already, gotta use 100% poly. I have tried different 50/50 shirts and they wash out very quickly, due to not sticking to the cotton fibers.

It really depends on your area and market. I would be around $500-$600 range.

I will only put my logo on it if it's a donated banner for a charity event. Other than that the customer is not paying my to advertise on their banner.

My Mimaki runs SS21 inks and boy howdy, if my exhaust is not running the fumes give me a terrible headache. I would think though even if you can't smell it, it can not be at all that good to breath for an extended period of time. I think they all should be vented to some extent. Just for piece of mind. My liitle home made exhaust system from Home Depot works great and ran me about $75.00.

I love Sanmar. I can order before 5pm and my shirts are at my front door next day.

I really like Joto's Ultra vinyl. It has a great feel to it and depending on the shirt it really sinks down into the fibers. It's also less expensive than siser.

PM sent

I have a Geo Knight DK20S for sale. Which is just what your looking for in a heat press and I'm right across the border from you . New the are right around $1400 and with shipping, cause it weighs nearly 200lbs, it would cost you $1600. Actually more since your up in Canada. Mine has been used lightly, probably only 50 shirts have gone through it. I just don't use it enough. I'm asking $1100.

I would be somethings up with the file, so I don't know, it might be a bad file. When I go to cut it, a box comes up and wants me to debug. If you select the "debug" button it opens up a macro editing box. If you choose "end", it renders the file dead and says coreldraw not responding. I think I'll start over and dump the file

I made a logo design in coreldraw x4 and worked on it for a few days and just recently when I would open up the file it will ask me if i want to enable or disable macros. What could I've done to get that pop up? and is it normal. :-

Yep, that works is Robomaster, but using the cutmaster 2 plugin in CorelDraw x4 it goes right past and searches below . I think I might reinstall cutmaster and see it that fixes it. It seems to be a little buggy lately.

Where does every one place the laser eye when lining up to cut? I'm sooo hit and miss. This is the first time using a laminate and it can't find the reg mark and the weird thing is the red dot goes right over it.

I did. I think I just played with too many functions and got a little confused. Things are working as they should. Thanks for asking