bigmax

Members
  • Content Count

    695
  • Joined

  • Last visited

  • Days Won

    13

Posts posted by bigmax


  1. Sorry , had to step away for a bit. I dug out a serial to USB adapter that I kept from my SC (old) model I used before getting the titan 2. Hooked it up (com port 3) Finally got the GREEN check showing connection however, when I click on cut, then click proceed with cutting.......nothing happens. Any suggestions at this point?Iuninstalled  and re installed but as soon as I plug into the usb port I get the "device not recognized" Goin nuts!!!

     


  2. My titan 2 stopped cutting in the middle of a time sensitive job. .Stopped and started over and same problem. Completely closed vinyl master pro, started again and getting a pop up that usb connection in not recognized by microsoft windows. SO........ uninstalled and downloaded VM Pro from us cutter web site. Still getting same message. Machine is grounded. RAunning windows 10. ANY assistance would be greatly appreciated!!!!!!!!!!!!!!! 


  3. Sounds like excessive pressure. Even vehicle tires sitting on a solid surface will have a tendency to get "out of round". Just my $.02I would relieve the tension and then run it back and forth several times starting with minimum pressure and increase the pressure in small increments. This MAY round it back out.


  4. I sure hope that ALL our forum members are WELL and SAFE. As for me, I'm keeping to the Homefront and completely avoiding contact with anyone other than immediate family (wife and daughter)My brother lives in Madrid, Spain and it is really awful there according to  our conversation yesterday.  Hope everyone here makes it through this "life altering" situation. Truly, BEST WISHES  and STAY SAFE!!!

    • Like 2