GHEENEE1

Can the Titan 2 with a stand, be used as a tabletop cutter, without the stand?

The 45 degree blade offset I have set for my Titan 2 is .30, is this a correct setting?

Thank you! .30 works, just checking.

I purchased a new cut strip from US CUTTER, for my Titan 2. The adhesive is on the backing instead on the nylon cut strip. should I return or can I fix, I haven't removed all the backing. And there is no adhesive in the cut strip channel.

Would contact cement work? I have that.

Cool didn't even think about turning it over.

What is the best way to install a new cut strip, on a Titan 2 28"? The manual says to apply heat. Without adhesive how would this work?

Thanks. Wonder why there is tape over the existing cut strip.

How do you move the pinch rollers on a new Titan 2? Some of my pinch rollers aren't over the grit rollers. New from uscutter.com. Not even set up yet. Also does it need to powered on to do this?

The pinch rollers did move, just very tight. New 3rd cutter didn't want to break a roller. Fyi, the man. did not help describing how tight they were.

How do you move the pinch rollers on a new Titan 2? Some of my pinch rollers aren't over the grit rollers. New from uscutter.com. Not even set up yet.

I have taken off my pinch rollers off of my GCC expert 24. Examined them with a magnifying glass and bright light. No cracks. Does anyone know if the springs lose tension over time? This cutter is eight years old. It cuts fine. Tracking issue with all vinyl.

I put 3 new pinch rollers on a EX 24. Tracking issue solved. No cracks. just the springs were bad. 8 yr old GCC tracks like it should.

Thanks

May try two see if it works least I'll know. http://www.jsisigns.com/cgi-bin/commerce.cgi?preadd=action&key=GCC-P-ROLLER-EXP

The tracking is off in every way, initially, prefeeding it, cutting. May buy a new cutter. After 8 yrs. it's paid for itself many times. Just started this week.

Yes the tracking occours feeding it back and forth and cutting.

Not cutting, notice the tracking issue while pre feeding. Thanks for the help.

Thanks for the replies, my laptop with Windows 7, as I load Robo gives me a message "failed to add printer" I have tried several ways to add the Craftrobo as a printer. Has anyone had this happen? If so is there fix? Thanks. Mike

Will the Craftrobo CC330-L-20 with Windows 7 Home premium 64bit cut with Robomaster? I'm having trouble installing the driver update from the Graphtec site. Any help with installation would be greatly appreciated. Thanks, Mike

Where do I install the 64 bit driver upgrade so the Craftrobo can make use of it? The Craftrobo is not showing up in my printers folder as it does in my XP desktop. Also after I install the Robomaster software, with the power disconnected the cutting icon is greyed out. Cuts great with Xp. Mike