GHEENEE1

Can the Titan 2 with a stand, be used as a tabletop cutter, without the stand?

Thank you! .30 works, just checking.

The 45 degree blade offset I have set for my Titan 2 is .30, is this a correct setting?

Would contact cement work? I have that.

I purchased a new cut strip from US CUTTER, for my Titan 2. The adhesive is on the backing instead on the nylon cut strip. should I return or can I fix, I haven't removed all the backing. And there is no adhesive in the cut strip channel.

Cool didn't even think about turning it over.

Thanks. Wonder why there is tape over the existing cut strip.

What is the best way to install a new cut strip, on a Titan 2 28"? The manual says to apply heat. Without adhesive how would this work?

The pinch rollers did move, just very tight. New 3rd cutter didn't want to break a roller. Fyi, the man. did not help describing how tight they were.

How do you move the pinch rollers on a new Titan 2? Some of my pinch rollers aren't over the grit rollers. New from uscutter.com. Not even set up yet. Also does it need to powered on to do this?

How do you move the pinch rollers on a new Titan 2? Some of my pinch rollers aren't over the grit rollers. New from uscutter.com. Not even set up yet.

I put 3 new pinch rollers on a EX 24. Tracking issue solved. No cracks. just the springs were bad. 8 yr old GCC tracks like it should.

Thanks

May try two see if it works least I'll know. http://www.jsisigns.com/cgi-bin/commerce.cgi?preadd=action&key=GCC-P-ROLLER-EXP

The tracking is off in every way, initially, prefeeding it, cutting. May buy a new cutter. After 8 yrs. it's paid for itself many times. Just started this week.