carolinatc
Members-
Content Count
15 -
Joined
-
Last visited
Community Reputation
0 NeutralAbout carolinatc
-
Rank
Member
- Birthday 01/01/1
Profile Information
-
Gender
Not Telling
-
thanks for all of the help!
-
thanks, i never thought about doing it that way.
-
I'm putting a solid strip of vinyl across 8ft. of polymetal (vinyl is 10"x96") would it be best to do the hinge method dry or do it wet? I'm using the clear transfer tape with 951 oracal. never used the wet method so any help would be appreciated. thanks, tom
-
thanks for the help! tc
-
I'm putting together a 8'x8' sign (two 4x8)(aluma-corr) Will be supported around the perimeter with 2x2, my concern is where the bottom of the top piece and the top of the botttom piece come together, there is no support there. I'm concern about the two pieces weaving in and out over time. I really don't want to put a 2x2 across the middle of the sign. Any ideas on how to support this or will it even need to be supported? Thanks for the help! TC
-
Thanks for the info.! You guys are the best. TC
-
What would be the best substrate for a 48''x96'' sign.? It's going on a corrugated metal building(not flat) also it's facing east and gets hit hard with morning sun. Thanks! TC
-
How do I get my cutter to cut all the way across? copam2500, sign cut 2x. When I make a cut, it cuts on the right side, and when I make the secound cut, it cut right behind the first cut. I'm wasting a lot of vinyl. What do I need to set up to utilize the left side of the vinyl? Hope this makes sense. Thanks, Tom
-
Thanks guys I'm up and running.
-
double checked, no 9 pin cable. when you say choose the right setting, is that in my control panel or the signcut software?
-
I'm getting ready to hook up my new Copam 2500 with signcut 2x, should I use the USB or the 25 pin parallel port cable? There is a 9 pin serial port cable male receptacle, but I did not receive a serial cable. I'm a newbe, so any help would be appreciated. Thanks, Tom
-
Thanks everyone! I really appreciate your opinions. I'm going to give USC a call. I'm thinking sign cutter 2x for the cutting program. TomC
-
Hello all, first post! Getting ready to buy a Copam24. Should I get it on Ebay and save a few bucks or from USC and get the extended warranty? Your thoughts would be appreciated! TomC