mikejr1212

Hello... I own a print/sign shop. I usually do print and cut. Some one came in and they want a wooden sign blue backround with gold router edge and gold letters.. Any one know of a company that will sell to trade? Thanks Dawn I attached a similar sign..

Hello does anyone know where i can get directions for assembly more specific then on cd.

ty... i did that and it worked ... the i resized it smaller and it went nuts again? any suggestions? ty

Ok here it is. Everthing else cuts fine but this font. Signblazer -Copam cutter

when i try to cut this image it just goes crazy in the middle and cutter starts cutting diagonal... does anyone know why?

MY COPAM PAM IS DOING SAME THING AS I AM CUTTING THE CUTTER CUTS OK FOR A WHILE AND THE JUST STARTS GOING UP A ANGLE FOR USUALLY FEW INCHES BAACK UP AGAIN ETC. ANY INFO?

THANK YOU FOR REPLY. I TRIED TO MATCH PORT BUT NO LUCK. IS THERE A DRIVER OR A DIFFERENT WAY

THE PORT I NEED IS USB COMM 4. IT ISNT LISTED

OK READ SOME THREADS HERE BUT IN SIGNBLAZER IT DOES NOT HAVE MY PORT LISTED? HOW TO FIX ANYONE PLEASE! THANKS MIKE

I INSTALLED THE SIGNBLAZER AND NO CD WITH CUTTER?

MY PORT IS NOT LISTED .SORRY DID NOT WORD RIGHT

HELLO AGAIN AND THANKS FOR RESPONSE. I CANY GET THE PORT TO CONNECT FROM LAPTOP TO COPAM RUNNING SIGNBLAZER. I GO INTO SETTINGS ON CUTTER PAGE AND CHECK UNDER COMM SETTING BUT DOES NOT HAVE MINE LISTED. MY COMM IS 4 FOUND ON DEVICE MANAGER.

OK READ SOME THREADS HERE BUT IN SIGNBLAZER IT DOES NOT HAVE MY PORT LISTED? HOW TO FIX ANYONE PLEASE! THANKS MIKE

TY all For all the help.

???Again the machine is making loud shimering noise when it cuts right to left or left to right .I bought less then week ago and it happend then and stopped tried cutting maybe ten times now still happening.HELP PLEASE