hotrodrichie
Members-
Content Count
51 -
Joined
-
Last visited
Never
Community Reputation
0 NeutralAbout hotrodrichie
-
Rank
Advanced Member
- Birthday 01/01/1
Profile Information
-
Gender
Not Telling
-
how do you add construction points to your job i have corel x3
-
in corel click on arrange then shaping then weld need to play with weld opt. for a while to see what it does
-
grimco inc.
-
grimco inc. is a good start
-
got any pics you care to show all so i know it takes a cnc but i want to see what is out there and what it cost for supplys
-
Eric where can a person bye stone or wood grain sign board for outdoors use I have looked all over and can not find any
-
i need a baseball all that i have tryed comes out realy bad
-
They work very well togather its all i use
-
if it cuts out your drewing and then it cuts adiag. line on it try turning of the weeding tool
-
Hay Ken i had this happen and it always did it as the cutter started to weed so i turned of weeding have not had it happen sence
-
turn on your cutter turn on your computer open signcut click on settings click on cutter settings and check your com port all so if you have PE need to start internet before you open signcut
-
when it does that pull down cutter settings and see if still conected to com port i get that when i start the sign cut program after i start the computer with a usb conection it is most likely droping the com port
-
i use corel draw x3 seams to be easey to understand for me go to corel.com can get a free trial run
-
ken when i try to send to signit X2 it works ok but it has severail diferent things you can do all of them work ok only one is not working is the stripe tool i am still in the design stage at this point not trying to cut just get job made
-
I dont know what your doing or not doing but i cut from corel X3 to sign cut X2 on a mh721 and have had no probloms eather settings is wrong or need to turn work 90*