dhollins

Anybody?? What other options are there in identifying these fonts?

Hi. Can anybody identify these two fonts? I have search and search but nothing. I also tried whatthefont but keep getting an error message. Thanks.

Thanks for the link. Yes, the cutter does a test cut from the machine just fine and the com port in device manager & in the Signblazer software is set to com 5. Don't know why it won't cut. I may try re-installing the driver and the Signblazer software again.

I have had my cutter for about 6 years now. Today I cannot get it to cut at all. I have tried two different laptops, a serial to USB cable and the regular USB cable that came with the cutter but still nothing. I'm using Signblazer and I have tried each setting under device manager on my laptop (Hardware, none xon xoff). Each time I have tried different laptops, they reconize the connection but won't cut. Looking at the computer screen you would think its cutting but the cutter is as quiet as a mouse. Can anybody help me here?

Thanks! I'll give it a try tomorrow

Thanks. I checked specialty graphics out on yesterday. They don't have 8 1/2 x 14

I printed for 40 shirts with cis and hardly noticed ink moving jhelms I'm just about sold on this printer. Currently using a Kodak ESP7 (comes with pigment ink) with great results. But I would like to print larger prints. Those that are using this printer, do you ever have any problems with clogging?

Where can I purchase some of this paper in 8 1/2 x 14? All I see is 8 1/2 x 11 and 11 x 17. I would rather not get the 11 x 17 and have to cut it.

Has anyone tried and mastered this yet? I'm getting more and more 100+ orders and all this trimming is getting to be too much. Most times I just throw a border around it to avoid all the trimming but some customers don't like the borders. I have a Laserpoint 24 and signblazer. Can someone give me a step by step process on doing this contour cutting on transfer paper?

I think the original poster is asking about graphics not transfer paper....

Nevermind I got.

Figured out its not a screw. It actually pulls right out in the opposite direction. Its the laserpoint with the white wire connected to it. But I can't seem to figure out how to get it off this old one with wire attached so I can put it on the new one. The white wire leads to a sort of motherboard. I thought it would just slide or snap off the motherboard, but it doesn't. I would post a another picture of it but the board picture capacity appears to full again.

Okay. Here is the picture I was talking about in the previous post. Can anyone advise me on this?

Okay. Levi, I see what you are saying now. Thanks. I didn't see that real small black hex screw at the top. Bare with me cause I have one other question. On the attached picture, you see that small black thing that I'm pointing at with the blue pen? It has the white wire on the other side of it. How does that come out to put on the new carriage arm? EDIT: Sorry, couldn't upload picture. Something about upload full;contact administrator. Thanks.

It appears those instructions Levi posted are for the Creation PCUT. This Laserpoint don't even have a hex screw to remove. I'm a lot lost of this one. I know its probably simple but can anyone dumb this down a little bit? Help.