-
Content Count
185 -
Joined
-
Last visited
Community Reputation
1 NeutralAbout smithmotorsports99
-
Rank
Advanced Member
- Birthday 01/01/1
Contact Methods
-
Website URL
http://www.smithmotorsports99.com
Profile Information
-
Gender
Male
-
Location
Minot AFB, ND
-
Yes as I was putting it on the car I noticed that. I am going to outline the gold in 1/4" red. That should help seperate it. Stupid mistake on my part.
-
Hello Everyone, Just wanted to show the final product and thank you all for the amazing help again!
-
I think I got it. Hope it cuts out well
-
I just downloaded inkscape again to try that program out. I must be losing my touch. I can win to save my life.
-
I tried with signblazer and flexi to try and trace or vector the gold portion of the # with no luck. I can somewhat get the red portion. But am trying to get the gold part so that I can redo the outline bigger or smaller if needed. The gold section has more defined points and curves than the red outline. Thanks!
-
any chance I can get help with the #7? I just need the 7 I can do the outline for sure.. thanks!
-
Thamks! This will work out great!
-
I will have to give it a try. I just haven't done much of this since I moved back to the East coast. Been spending all my time getting my race cars together and not spending the time toying around and learning. I find if you don't do it regularly, you tend to forget. Oops! Thanks again though. Huge relief!
-
How did you do it by hand? I am asking because I think that is how I will have to do his number also.
-
ABSOLUTELY amazing! blew me away when I just got home to check it out. Thank you SO very much. I was stressing about this all day!
-
I think I found the welder Welder.bmp
-
He didn't understand that at all. He thought bigger was just stretching a corner of the image. This is gonna be painful.
-
Hi, I was sent this logo to redo for a racer in the area. Any chance someone can vectorize it? I'm having trouble with it being so small.
-
smithmotorsports99 started following Logo help