SEA_TEC

Thanks, Tek

Never heard of this font, and can't find it in web searches. Customer wants work done in this font. Any have this ? Thanks for any help. Tim

Hello, I have a project I am working on and can not find these 4 things. Any help would be greatly appreciated Thanks in advance, Tim

Just some playing around with my 2001 Z71

Today I woke up and sat down at the computer to cut, and nothing. I unpluged the USB and pluged it back in and got a Device Not Recognised Error. I can't uninstall it and it won't reinstall the drivers.... now what Any help would be greatly appreciated Thanks, Tim

I have the machine grounded, and the 4 mg chip installed.... why can't I cut this image without it freezing up about 20 seconds into the cut Rockford_Fosgate Tribal.ai Rockford_Fosgate Tribal.ai

Hello, Does anyone what font this is ? Even if you know of one that is pretty close. I need it for a project due friday, and I'm lost. Any help would be greatly appresiated Thanks, Tim

Hello, I'm looking for an old call box like they used to use to call the fire house. If anyone has one they are willing to share, I would really appreciate it. Thanks, Tim

Thanks Dave

Ok, I'm guessing I need to upgrade my memory on the cutter because it stops on large projects. It won't even cut tiles. I've looked all over and I can't find memory for these cutters anywhere. Do the take standard memory, labtop memory or what ? Thanks, Tim

I second that. I'd say I'm at the point where I need some tech support at this point. I can't get this to complete one job without cutting several times and using bits and pieces of each cut. I just can't afford to keep waisting vinyl like this. I have the cutter on carpet, and wired to the stand. Does it matter if the wheels are on the stand ? Could I run the ground wire to the floor vent ? Another thing I notice it is doing is when it stops, sometimes it goes in to ofline mode, some times it goes into setup, but most of the time I get a strange looking message that looks like the screen is broke, of messed up with wierd lines througn it. When I hit reset, it goes back to normal. Not sure if this makes a difference or not.

No I don't, but would memory cause it to just stop in the middle of a cut or to end a cut and reset it's self before the cut is finished

Ok, I ran a ground wire from the cutt the stand. I tryed again to print thr image I've been working on all day it ran longer before it frose. then i tried again and it ran got maybe a min before it frose again... Would love to know what the deal is here... the is getting very expensive !!

I'm not sure what you mean. It is plugged into the wall, not a surge protector. The machine sits on 4 rubber posts, and the posts sit on the stand, but the stand isn't touching anything but the floor How would I ground it ?

Ok, I'm lost, My MH-1351 will cut the image below in 12x12 just fine. It even cut it in 24x24 Now I am trying to cut it for a hood 42x42 and it stops after the dogs head and cutter head reset itself. I deleted what it had cut and tryed again, and it stoped after part of the neck and 1 long curve and stoped in the middle of the cut... I'm getting tyred of waisting vinyl here... what am i doing wrong ? Wolfshead.ai Wolfshead.ai