TaganCO

Think I got it figured out. My pressure wasn't set high enough?? I cranked it up to 120 (usually I only cut at 90). What's the 'standard'?

I've been using my Creation PCUT for over a year now with no major problems... tonight I went to make a few cuts and it seems like my knife drop is delayed. Are there settings that I could be overlooking? Do I need to oil something? I've played with the pressure, switched out my blade and still get partial cuts (because the blade drops so slowly). I have also played with my cut speed, fast or slow I get the same results. Someone please help!

I've got 4 Gigs so I should be fine. I run photoshop for hours on end with no problems... Could it be a bad cable? It's almost like I loose the connection all together and rebooting "finds" it again.

Ok, so I am pretty new at this but so far I've made a bunch of cuts, imported vectors and all is well... EXCEPT for when I try and cut from Signblazer. I am running XP, have a PCUT 630 and I am connected with a USB cable. My com has stayed the same and none of my settings have changed in Signblazer (I double and triple check this all the time) but if I have been working on my computer for a while and then try to cut something I get an error that there is no connection to the cutter (I don't remember the exact verbage) and when I reboot it cuts fine! Anyone else out there had this happen? Help, please!