Just set up my SC cutter today. I can cut one project out but after that if i go to another proj. i keep getting this error and have to shut down and reopen. Any ideas.
USCutter machine cannot be found.
ok, knowing that i am no digital techy person, i still need to know where to get a longer cable for my SC series running SCAL Pro. I am using the USB so will any usb cable work as long as the ends are the same.
thank you all for your help. i have set the blade to prs. 12 and the depth - well - i can't see the blade and it is cutting so much better. i was curious how a higher # ( 12 ) on prs is better than a lower # ( 2 ) . I guess that my logic is not made for the particulars of a cutter. Thank you again.
i barely see my blade and it still cuts thru the backing. Any tips on pressure. I have been told start at 12 on the SC cutter but that seems extreme. I have pressure on 2g and it still goes thru the back. What am i doing wrong. I just can't get it adjusted. Help
ok, so evidently my blade is out too much but looks barely out. I have my spd on 300 and prs to 2 g. and it still cuts too deep into backing. Can someone explain the pressure setting. I was assuming that the more pressure ( 12 g ) would make it worse but what i am reading here is to increase from 2g TO 12g. Trying to understand !!!
i see i have a lot of reading to do. i am on the verge of buying a cutter this week and am expoloring this site. Thank you all for the tips. I will need them to set up. Any preferences to the SC series as opposed to the MH . Really want to go pickup on Friday