Xaimill

Im using Illustrator CS6. CorelDRAW aint very friendly with me but I have it too so I could manage there as well, given the need.

Thanks! Now... How can I do that? I've seen other registration mark options on Cutting Master 2 (with Illustrator CS6) that offer extra Reg Marks. Which are recommended for use, and how do I make the machine read them? (like, it's aware there's more registration marks, not just 4 corner marks). Thanks again.

Greetings everyone. I recently got a Graphtec CE5000-60 (used), and I want to start making fullcolor stickers with contour cuts. However: 1) Sometimes the registration marks aren't read. I read somewhere that glossy material affects the ARMS, so any help on this will be appreciated as well. 2) Noticed that contour cutting isn't as perfect as in other videos I've seen, there's always a bit of misalign, hardly perceptable, since the start of the cutting (even after reading the Reg marks) 3)On long media cuts, it starts almost perfect (first picture), but displaces horizontally in the middle (second picture), and then ends up almost perfect again at the end (third picture) -IGNORE the inner outline, the outwer one is the contour cut- Start (feed direction <---------- left) Middle contour cut (feed direction V, down) End cut (feed direction, down) This is a picture of the whole test page I made. Any help will be highly appreciated, as I got some arts that aren't coming out as they should and is very frustrating. Thanks to everyone in advance.