N8R

Thanks for getting back with me. I figured it out. Everytime it starts to cut it hits the limit switch on the right and goes into reset. The new problem is when I set the reference point in the right corner and put it back online, the image I see on the production manager just before I send is upside down/backwards when it cuts and it sends it back against the limit switch. If I set the reference point the width away from the right it will cut without problems. Any suggestions?

I just purchased this new from Ebay and setup according to the instructions. I have the 8.5 starter software. I have it hooked up to my serial port on my laptop with XP and when I try to cut, it starts up the production manager and then I have to send from there to start cutting. Production manager shows cutting and deletes as soon as it reaches 100% but the cutter display shows waiting and cut head doesnt move. Any help would be appreciated. Thanks Nate