amillea

Members
  • Content Count

    3
  • Joined

  • Last visited

    Never

Community Reputation

0 Neutral

About amillea

  • Rank
    Newbie
  • Birthday 01/01/1

Profile Information

  • Gender
    Not Telling
  1. amillea

    cutting problem with Roland CAMM-1

    In the meanwhile, I managed to solve the problem. The five-line flexible wire connecting the mobile carriage to the up-down command signal source was defective, randomly interrupting the path to the carriage. Replacing it completely eliminated the problem. amillea
  2. Hello! I am using an old Roland PNC 1100 cutter, that still works perfectly, except a "bug" which appeared only recently. Some lines are not continuously cut out, but they are interrupted, the length of this "break" being 1/2 to 1 inch. This happens only along the right side of the vinyl sheet, at a distance of 1...2 inches from the movable roller. Due to an unknown reason, the knife is raised within this part of the curve, instead of remaining in the "down" position. In never happens in the rest of the sheet area. Note that the issue has a random character, it occurs accidentally, in an unpredictable way. The same situation when using Flexi or Signtools. Any explanation or possible origin ?
  3. amillea

    breaks in the cutting lines

    Hello! I am using an old Roland PNC 1100 cutter, that still works perfectly, except a "bug" which appeared only recently. Some lines are not continuously cut out, but they are interrupted, the length of this "break" being 1/2 to 1 inch. This happens only along the right side of the vinyl sheet, at a distance of 1...2 inches from the movable roller. Due to an unknown reason, the knife is raised within this part of the curve, instead of remaining in the "down" position. In never happens in the rest of the sheet area. Note that the issue has a random character, it occurs accidentally, in an unpredictable way. Any explanation or possible origin ?