-
Content Count
6 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Everything posted by MacCutter
-
Link for step by step Mac and cutter setup. Thanks, BannerJohn!
MacCutter posted a topic in Mac Users Board
Banner John posted a link that has a step by step howto, pics and all, setup walk through. Hope this gets you up and running as soon as you get your cutter out of the box and put together. Here's the Link: Start.uscutter.com -
What would be tue best way to remedy this?
-
Ok USC form family, I've had my cutter for almost a month now and just last not got it talking to my mac. Thanks again to BannerJohn for posting this link Start.uscutter.com. I uninstalled the FTDI driver and installed the one from the TrippLite site. Reinsatlled SCPPro and things started to happen when I sent a cut of the SCPPro logo using the pin, of course. I was ecstatic. When it got to, I think, the 2nd layer cut(plott), my cutter went left. I mean litterally, it went all the way to the left and came back. On the next layer it did'nt cut(plott), it it didn't cut(plott) it all out. When it was all said and done, the layer were offset, there were cuts(plotts) made that nothing to do with the file at all. What could be causimg this!? Any help is greatly appreciated. MacCutter
-
noob setup issues mh871-mk2 and signcut
MacCutter replied to jnolandesign's topic in Mac Users Board
Try this link posted in the thread "New website for cutter setup" by member BannerJohn. If it helps send him a thanks. He's in the member directory. http://www.start.uscutter.com -
Cant get MH721 to work with either of my mac's
MacCutter replied to tharealmclovin's topic in Mac Users Board
Try this link posted in the thread "New website for cutter setup" by member BannerJohn.http://Start.uscutter.com If it helps send him a thanks. He's in the member directory. -
New Website for Cutter setup
MacCutter replied to BannerJohn's topic in Community Rules & Announcements
Hey Banner, Just found this thread and can't wait to get home to try it. I've been alittle heated in the fact that i couldn't get my cutter up and running for the past few weeks, since I got it. I have to say this is the most complete, clear, and direct set of information I've come across to date. I'm sure it's going to work. Thanks in advance.