patricel67

I am using serial connection and I have the blade carriage cover off. Any other suggestions...... PLEASE!!!! Thanks in advance.

I have check the file for nodes and I do not see any that should not be where they need to be. I have cut this file and several others alot of times and have not had problems before. Like I said. I changed the blade and now it does it in more then one file. so for I has done it to about 8 different files that are cuts with alot of lettering. PLEASE HELP!!!!! HJ011_BeinghappyII.eps HJ011_BeinghappyII.eps

I have a pcut creation cte630. I use SBE for my cutting program. I have just replaced a blade in the carriage and now when I cut something with a lot of lettering it will cut a line through a few words and not through all. I have to recut that section of lettering and replace it before I tape it. It is becoming very frustrating because it just causes more work for me to do. Can anyone help me with this problem.. Thanks Patty

DDunning, where can I find the Renfrew High tack R-tape. Does it have a high tack? Thanks for you post.

Can someone suggest maybe I use a very high tack tape? What is the best transfer tape to use for this problem. HELP!

I am using Oracal Matte vinly 631 and signwarehouse enduramask high tack tape. For some reason my customers are complaining that the vinyl will not stick to tape, even if they rub it again really hard. When I apply the tape I use a very hard squeegie and alot of pressure and still no luck. Can anyone suggest a good transfer tape that I can use to solve this problem. I use the matte vinyl because it looks best for indoor wall sayings. I have used about 1/2 the roll of transfer tape and it still is not any better. Please, someone help.. Thanks in advance

Sorry, but this issue has to do with the blade holder not dropping down to cut at all. It is a problem with the carriage.. But thanks for your reply

Ok, I will be contacting uscutters today. Thanks alot for your time and help

What do I need to do from here? Do I need to contact someone? Thanks so much for all of the help. This forum is awesome!

I also unscrewed the bottom and wiggled connection on the motherboard. Any other suggestions?

Yes, it still would not lower the blade when I tried the test cut from the machine only...

The arm is connected. When I press up and down on the bar the blade will move up and down. Any other suggestions?

everything looks normal just like the photo's posted and still no dropping of the blade. tried test cuts, turning off for over 5 minutes a couple of times. unplugged, plugged back in, disconnected serial cable during test cut. any more suggestions?? any reason to check motherboard since it was working fine and all of the sudden quit working?

Where would I find the motherboard? Is it on the end by the usb port?

Yes, I tried that as one of my first things....