dh designs

so I figured out what was wrong. I set it up like was said on the uscutter site they say to select one of the pcut settings but after the above post saying liyu driver I looked on the list and well liyu was there so I selected it an now good to go.....

using the driver off of uscutters sight, not sure about if its liyu or not ?

ok first off I have a laserpoint cutter and have been running it on signblazer for a while now so this is not my first cutter. Anyway my problem is I just bought a used SC cutter my plan was to use this as a backup or to take it to events and use onsite, so I loaded signblazer on a laptop and set it up hooked the SC to it and go to cutting, the only problem is the cutter is cutting in "mirror" when the signblazer is set to normal and when I switch the sighblazer to mirror it cuts "regular" is there something in the SC that I can change to fix this ?? Thanks Danny

ok so I've done things the same way for like 14 times (according to the trial starts) in the software, I do my artwork in Coreldraw and copy and paste into signblazer adn it worked flawlesly until just now. I did a cut and then tried to bring in a new one and it just keeps poping up a " cannot import this file it is a improper CPX file " popup. I don't understand why all of a sudden it's doing it. thanks Danny

so I bought a roll of clear application tape from this site and when it showed up there are some "creases" in the center of the roll, now this is my first time buying any vinyl or application tape, this is'nt normal is it ? I think the roll is messed up since the creases dont realy come out when trying to put it on the vinyl. the tape I bought was the "sample" roll of greenstar clear tape ( 24" x 100' ) here is a pic of the roll. thanks Danny