bikemike

Members
  • Content Count

    1,038
  • Joined

  • Last visited

  • Days Won

    74

Posts posted by bikemike


  1. With what you are describing and it is warped, at the most it is around .002". Good luck measuring that.

    Set your blade as per Skeeters directions, and set your pressure as per trial and error.

    The blade holder does not bottom out when down. It only goes down to the vinyl with the pressure you have set. There is more travel and should follow the vinyl along the full width of the machine.

     


  2. 14 hours ago, Worble7 said:

    I know it's something simple I'm missing but I can't put my finger on it......This is what the cut screen looks like after I did both colors and still not showing up in cut. I have 4 windows as where i think I should have 2 correct? I come and tinker every few days so I don't lose my mind. Thanks Jeff

    10-30-2021 5-10-23 PM.jpg

    Go back to the design screen and make the 2 blacks (design and reg marks) the same color.

    Make the 2 browns (design and reg marks) the same color.

    They are not the same and why you have 4 and not 2.

    That will fix the problem.

    • Like 2

  3. Maybe. First off you will need a carrier for the card stock or you will not be able to without destroying your cutting strip and trashing your cutter when the pieces start to lift. Second, depending on the thickness, and if you have the pressure to actually cut the stock, you will go through blades like crazy. 

    I have seen templates on line, but can not remember what the site was. Goggle should help with that. 

  4. Help


    It's a boat. Fishing boat. 

    I see you posted in the font section. 

    It would be nice if your first post actually said something. A post like that tells me you are demanding something.