Carlosgraphic

Hello. I wanna know if somebody have working Flexisign 8.6 v2 on MH-871. Does this software work well on it? Any issues? I have MH-871 cutter and Flexisign 8.6 v2 and it's working on it. The software works well, but when I cut something, the carriage doesn't come back to the original point. This one remains paralyzed in last point of the cut. If I going to do another cut, the cutter will cut erratic, so I have to push reset. Normally, this issue doesn't happen on SBE, but I would rather use Flexi. If you have flexi and it's working well without this issue. Could you share your configuration on setup to compare it, please? I did this post before, but I think it wasn't in correct section. Uscutter refine MH-871. Ground was tested. Windows 7 64 bits Flexisign 8.6 v2 port by USB cable. Thanks.

Ops. I'm sorry. I wasn't my intention. I didn't know.

Thanks Skeeter. I know my question was answered, but I'm looking a light in the end of path. It is a problem of the machine bios or a driver problem with flexisign? I am only clearing doubts. Thanks Mr.Skeeter.

Hello! I'm new in this forum. Well, my question or problem (I don't know yet) is the following. I recently bought a MH-871 uscutter. I installed it follow to the instructions. The cutter is working with flexisign software, but I have seen something strange on the cutter. When I cut something, it finish well, but the carriage stops in the last cut point. I have to push the reset button, so the carriage come back to initiation. The cutter doesn't make it by itself after a job or cut. In consequence, If I leave the carriage in the last cut point, and I wanna do another cut then the cutter begin a erratic cut. I have to cancel the printing/cutting job, push offline/pause, and turn the cutter off and come back turn it on again. In addition, I cannot print again if I only push offline/pause and I cancel a printing/cutting job. I have to turn off/on the cutter necessarily. Thanks.

Flexisign 8.6 and Windows 7 64 bits. Postdata: It works well with SBE, but I would like use Flexisign because It is less complicated to import images from AI. I'm unable to import some images from AI to SBE, but I can do it with Flexisign. I think flexi is more friendly than SBE or SC. I can import images without problem, make single designs and move them on preview before cut.