Hello,
I purchased 2 additional pinch rollers in an attempt to limit the amount of drift I am experiencing. I run it out the full length of the cut before dropping the knife and it doesnt drift at all, but as soon as I start cutting it goes absolutely crazy. So, I figgure that the rollers arent holding it tight enough against the friction of the knife. I need instruction on installing these additional rollers. I have looked for instructions for about 30 min and I am now asking the list for assistance.
Visual instruction would be nice, but I will take anything at this point before I dig into this.
I have the pcut 630
Thanks
mike in NE PA