Constrictor

ok maybe im just dumb but i downloaded that file and i dont see any executable files in that zip.

i have went there and have not found any drivers specific for my mh365 cutter. I think i can do without the usb driver and us 25 pin connector if i can get the settings in sink i am not sure where in signblazer to set up the ports and settings. I am getting an error message when i try to cut, it says "cannot open the output device,error initializing cutter" also the red light is on by the reset button, is that normal?

I have a mh365 cutter and finally got signblazer installed and authorized. Now i need to get the software to run the cutter working. The manual says you dont need any software unless using a usb cable? Ive tried downloading the driver for usb at http://uscutter.com/download/u11driver51706.exe and the link doesnt work. any suggestions?

where to download the driver for usb for the mh365? i tried the link on the uscutters website and the link was dead.

Ok finally got down to trying to install the USB software since my new computer only has usb connection, and the installation disk doesnt work and the path listed on the instructions does not exist. Went to the uscutter website to download the driver and a hotlink showed it downloadable but when i clicked on the link it was dead. Any help on software drivers?

I recently purchased the MH 365 machine for cutting vinyl for my RC airplanes. The unit looks to be made well, came with all the cables needed, and came with a drawing program that says it can only be installed on one computer. The unit came with very little instructions, it does say how to install drivers but nothing about what process you use to make the cutter cut from the computer. I also would prefer to use Autocadd as i am very familliar with it. Any ideas?