dawm

Found this at IKEA and so far it works great.. and was only $14.99 Part #: 000.114.28 http://www.ikea.com/us/en/catalog/products/00011428/?query=000.114.28 I just left out a few of the bars when I put it together, then I screwed it to a piece of wood (since its wider than my table) and then used shelf brackets to secure it to the end of my table. I'm going to add knobs to the bar that the rolls of tape go on so its easier to remove (instead of keeping the allen wrench near by). And/or replacing the screws with studs so that it can spin freely.

uscutter refine mh721 via serial via my prolific usb to serial adapter.

ugh yeah it appears to be signcut, i just installed signblazer and ran one of the same files and it cut it almost perfectly (weeding cuts were off but it was an accurate graphic) this sucks.. signblazer looks and works like poop compared to signcut, ill have to see whats wrong with signcut now.

The graphics look as they are supposed to in SignCut, even in preview mode with the preview cut animation all looks as it should. I havent tried any other software yet. It does it on any file.

Just got my cutter yesterday and everything i cut turns out like shown above. (correct image is in white & black) As you can see from the image there's a common issue besides it over cutting and making the wrong cuts, the 90 degree cuts are end/start with an angle. It doesn't matter how big or how small or how fast i have it set to. I'm using a new MH721 (grounded) w/ SignCut and my blade sticks out about half the thickness of a credit card (as recommended) any idea's? cause this is real upsetting. also the 'TEST' cut goes perfectly.