candidogarciajr
-
Content Count
8 -
Joined
-
Last visited
Everything posted by candidogarciajr
-
We was trying to cut a circle graphic the first four are perfect but the last four when it comes to a full circle it does not connect it misaligned does anyone have that same problem or has a solution for it thank you
-
Cutter not cutting properly
candidogarciajr replied to candidogarciajr's topic in MH Series Vinyl Cutters
Thank you so much for help have a good night -
Cutter not cutting properly
candidogarciajr replied to candidogarciajr's topic in MH Series Vinyl Cutters
Sorry was busting my head over this but I think I got it is this better -
Cutter not cutting properly
candidogarciajr replied to candidogarciajr's topic in MH Series Vinyl Cutters
Kool I tighten too cause I testing it and a 12x12 cheap vinyl I tighten to the point where the screw does not come out of the outer housing -
Cutter not cutting properly
candidogarciajr replied to candidogarciajr's topic in MH Series Vinyl Cutters
So basically leave enough material so that the cutter can pull freely and leaves the vinyl roll alone? -
Cutter not cutting properly
candidogarciajr replied to candidogarciajr's topic in MH Series Vinyl Cutters
Ok I did mess with the pinchers cause I felt they were too tight and it was leave marks on the vinyl.wqs it wrong of me to mess with it? Also can you explain about the plotter pull? -
Cutter not cutting properly
candidogarciajr replied to candidogarciajr's topic in MH Series Vinyl Cutters
This is how it's cutting -
Cutter not cutting properly
candidogarciajr replied to candidogarciajr's topic in MH Series Vinyl Cutters
What do you mean the vinyl itself?
