Graphtec-CE50-LITE

Members
 View Profile  See their activity

  • Content Count

    3

  • Joined

  • Last visited

Community Reputation

0 Neutral

About Graphtec-CE50-LITE

  • Rank
    Newbie

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Graphtec-CE50-LITE started following Grapthec CE 50 LITE quality cutting issue and Graphtec FC8600 Contour Cut Alignment Issues
  2. Graphtec-CE50-LITE
    Hello, I had that issue too as the pinch rollers springs were too loose.
  3. Graphtec-CE50-LITE
    Hello, In my case the problem was coming from the pinch roller spring (Graphtec CE-7000). The Graphtec reseller in my country changed the springs as there was too much pression on the pinch rollers which were causing the vinyl to wave (bunching, tracking issue). After replacing the springs the bunching issue went away but started to misalign as the OP message. Changed the spring back with the original springs and fixed the misalignment issue right away. Hope it helps...
  4. Graphtec-CE50-LITE
    Hello ! I have an issue on the cutting quality as you can see on the picture attached. I have tested the offset from to , "-2", "-1", "0", "+1", "+2". "0" seams the best choice but still not perfect. at "+2", it fixes the issue on the attached picture but similar issue appears elsewhere. Would you have any clues ? Configuration : Vinyl: Stahls SP or Siser PS (not sure) Grapthec CE 50 LITE Knife: 2 Force: 11 Speed: 15 Acceleration: 2 Tangential: Off Distance Adjust: Off Thank you in advance !