MrGilleys

I’m printing a length of “ 10 “ and then printing the same thing again, only problem is the origin set by the machine once it’s finished the first run it right on top of the previous line.. Im wondering if there is a to fix this other then manually changing the origin on the plotter (Graphtech CE7000) Any help would be greatly appreciated

@MZ SKEETER I found the Graphtec CE7000 24" Professional Vinyl Plotter from a Canadian vendor for $3200 CAD - Any thoughts on this?

@darcshadow Yeah pretty random everytime, I just noticed actually the unit's fan isent on anymore.... Wondering if this may have caused the overheat and fried the chip you mentioned?

Im willing to buy a Non-Value cutter to be honest. Do you have any recommendations? I dont mind spending a few grand on a good cutter with good software.

OK, I got the drivers to take! found some online, But now im back to square one. Its not cutting what its suppose to be cutting, It just cuts all over the place

Ive been trying, It wont take it... Automatically or Manually. It says Windows cannot locate the drivers.. even tho these drivers are in the exact folder i select

Yes, none of them are being used.. last time i installed this program and cutter, I needed to install the drivers in order to change USB2.0-serial into COM3

Alright, Installed the suggested SBE program with no changes, Reasoning I'm needing the drivers is when i plug the in the USB cord it just comes up as saying "USB2.0-Serial" And within SBE that option is not there, It used to say COM3 instead of the USB2.0... The previously provided drivers for this wont work anymore I tried using the MH Cutter emulation you suggested, that did not work unfortunately

This machine and software have been working fine for the last 2 years, not today when I went to cut out some of my regular decals it just cuts all over the place and randomly.. Instead of cutting " ABC " It cuts lines all over the place. I have not changed anything on the computer to cause this, Looking for a solution, Im running low on my decals that I need for work Any help would be GREATLY appreciated! Attached photo of what the Cutter is doing instead of actually tracing the text UPDATE: Figuring it was a driver issue, i uninstalled the drivers for the USB - Redsail RS800C Plotter, When trying to reinstall drivers windows says it was unable to install drivers