MrXray

Hi everyone.... I have owned and used this LP2 for a number of years on a recreational basis. Recently i have had a few issues pop up that are really annoying 1. When cutting 15" vinyl the left side tends to lift up (and "bubble" for lack of a better term) while cutting even though the blade has not traveled past the material. I can only assume it's because the blade may not be lifting high enough to clear the material. any ideas or suggestions on what is causing it and how to avoid this? 2. This one is not new..... but I figured I'm here Might as well ask If I want to make a 10" decal or in one case I was making a pc to fit in a 12" area to fit a project perfect. after cutting the result was a little smaller. I then noticed everything i made was smaller than the size programmed. Is there a way to calibrate the machine so it is accurate in its cutting sizes. I made a vinyl to apply to a child's growth stick and it was not accurate. Thanks in advance for any help with these issues. It will save time and money avoiding re-cuts Ray

I have had my Laserpoint II for a number of years.... untill now all I have cut is your typical vinyl for decals, I have done stencils, wine bottle labels, signs, car decals, t-shirts, toilet bowl lids, plaques, and so on and so on.... What are the limits to the plotter? I know it does not cut tint. are there any other materials and things to use this for? or is it just vinyl. Thanks....any suggestions are welcome since retirement starts soon and I need to occupy my time.....lol Ray

every so often mine just stops dead and acts as you described......i have no clue why....i usually try again and it's fine......sorry you are having an issue

I realize this might be too late but.....this is what I got.... bus svg.svg