johnhaley

Members
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral

About johnhaley

  • Rank
    Newbie

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Hi everyone, This is kind of hard to explain. I poked around the forum a bit trying to see if anyone had the same problem but I didn’t see anything really. Ok…my problem. My cutter doesn’t completely finish the cut. It leaves behind a small connection from where it starts to where it ends so when I weed it, it snags a little. I changed the blade but the same thing happens. It’s a very VERY slight left over piece. It normally just rips apart but sometimes it leave behind a jagged mark on an otherwise clean cut. Thanks