tomr928

Skeeter thank you!!

So I had my order basically all set, but I was still reading, researching and learning more about the materials and equipment. So last night, although the items I was pretty sure i was going to order were in my cart, I decided to wait until today to place the order. Yesterday there was a discount for orders over $500, STIMULUS100, that reduced my cost by $100 but today it is gone, i read it carefully and there was no expiration that i saw or warning that this was the last day, etc. My question, do you think they would honor the discount seeing though I am a new customer or already had the items in the cart? And do they run that type of offer often and I should wait? I tried to call and no one answered. Thanks.

I did have a sign shop quote the stencil and that is why I am considering going this route as the cost is very close to the MH unit and obviously slightly less than the SC. At this point i think the SC is the way to go as there are more cars in my future and this will allow me to explore my creativity at a moments notice. Thanks again for all your help and sharing your knowledge.

Thank you Both for helping. On my project I an planning on printing custom, detailed stripes for the side of the car that could be 5 to 8 feet long. Are you saying that the MH machine might not track well causing a curve in the print or that it might not track well in that the print would be straight but may not stay aligned with the material? Thanks again.

Thank you! Very appreciated!

Sorry if these questions have been asked before but I am brand new to this, I will try to keep it short: 1. I am custom painting a car and wish to make stencils to paint over with automotive paint and then remove after shooting. Is ORAMASK 810S a proper selection? 2. Can an MH721 28” cut the ORAMASK 810S? 3. Is the ORAMASK 810S adhesive backed already, or do I need a separate material? 4. In the B-MH721STRKIT is the vinyl applicable for use on cars? Outdoor. 5. In the B-MH721STRKIT does the vinyl require a separate adhesive material? 6. If I purchase the B-MH721STRKIT will I be ready to set up and print or do I need anything else other than the material and a PC? Thanks.